3.6kw 220v High Frequency Induction Heating Machine Hardware Tool Heating Equipment Auto Spare Part
[32862758241] 3.6kw 220v High Frequency Induction Heating Machine Hardware Tool Heating Equipment Auto Spare Parts Car Bearing Heating Machine RMD-480 Bearing heaterfor mount or dismount bearings 3.6KVA,220V 1 phase. 16A. The technical Specification Rated voltage 220V (180-240V) 50HZ/60HZ Rated current 16A Rated Power 3.6 KW Max width of bearing 180 mm Inner diameter of Bearing 30-300 mm Max Diameter of Bearing 480 mm TIPS: Tallest temperature heating:270 Degree C. Packing with Heating Rods : 5pieces. Thermalcouple: 1 piece Heating yokes cross section size: 20*20 mm 30*30mm 40*40mm 50*50mm 60*60mm Packaged Weight with heating Rods:83 Kg. Bearing size reference. The operating procedures 1) Connect the power (220V) and instrument lights on. 2) Instructions in accordance with the instrument temperature, pressor"Up" and "down"Set the heating to the desired temperature,Then Press"START"to Start,press"STOP"to stop. 3) Indicated by the instrument time,press "Up" or" Down" Set the heating time required,press the "START", and start the heating. Press the "STOP" to stop. 4) According to the work piece diameter select heating yoke, the work piece is heated sleeve on the yoke (or set the pole), the yoke on the transformer two pillars end face and pressed activities of yoke. (Note: in the column end face of the to wipe butter.) 5) Sensor sucked into the work piece, press the "START", and start the heating. Press the "STOP" to stop. 6) When the set heating temperature (time) reaches the set value, the machine automatically stops working. 7) Remove the work piece after the end of the installation. Follow the operating instructions at all times. Must check before induction heater circuit, instrument ground is intact. The machine automatically detects the probe, in the absence of the probe or poor contact machine automatic alarm. Heating the work piece should try to choose a larger heating axis, in order to improve work efficiency. Bearing heating temperature should not exceed 120 degrees Celsius. Do not probe for a long time placed on the work piece in order to extend the life of the probe. Take the work piece must be wearing asbestos anti-hot sets to prevent burns. You must disconnect the power after using. The heater should not be used in areas where there is a risk for explosion. Risk of electrical hazard. Only qualified and adequately trained personnel must be allowed to operate the equipment. During the heating process observe a safety distance of 1 m (3.3 ft) withthe Induction Heater. Since a magnetic field is generated by the induction heater, peoplewearing cardiac pacemakers or having metallic implants must observea safety distance of at least 5 metres (16 ft) from the induction heater during operation. Electronic equipment, such as wristwatches, mobilephones, may also be affected. Use proper handling equipment when lifting heavy workpieces. Secure the workpiece with appropriate lifting and handling equipmentwhile heating. Make sure the supply voltage is correct. Connecting the induction heaterto the wrong voltage supply will void the warranty and probably damagethe heater. Always make sure the heater is securely connected to earth. Do not expose electronic components to high humidity or water. Never introduce body parts into the bore of the heater during operation. Do not use the equipment in case of damage or heavy wear is detected on the heating coil. Handle the coil with care to avoid shock loads and jamming during mounting and dismounting. Package: Wooden box. Term:DHL, TNT, preference. Payment Term: Paypal, Western Union, Escow T/T ok. More Products
US $2075.00Limited Time 0% US $2075.00
Tidak ada komentar:
Posting Komentar